![k dcan cable pin 7 8 k dcan cable pin 7 8](https://i5.walmartimages.com/asr/5efde4e0-b393-4cdb-a86b-16503ddc0ac1.496190df3bc9ccb279883e3926bc7d53.jpeg)
![k dcan cable pin 7 8 k dcan cable pin 7 8](https://m.media-amazon.com/images/I/71sBnU6MiUL._AC_SL1500_.jpg)
You only need to run it when you are switching between modes. Is it necessary to do so every time I want to use DCAN or is the interface staying in DCAN mode once I ran DCAN.exe? I have only used my K+DCAN interface with DCAN cars. As soon as you connect the interface to the car and your computer, run DCAN.exe to configure the comms rate. Is there anything else to do for switching from K-Line to DCAN then disconnecting pin 7&8? Unfortunately I don’t have a DCAN model available. Yes, I think connection by soldering is a bad option as it limits the usefulness of the interface, I have an adapter but consider a switch to be a better option. So you have to physically connect (K-Line) or disconnect (DCAN) pin 7&8? Mount a small switch on the OBD plug end of your adapter, which can bridge (for K line) or separate (for DCAN) the connection between pins 7 & 8.Use an adapter (such as the one sold by One Stop electronics) which internally bridges pins 7 & 8 or,.The 2 most sensible options are both hardware-related:. I assume the reasons being that on DCAN cars one pin is used for a ethernet connection and the other to the K data line - on K line cars, both pins are connected to K data lines and that creating a switch mode circuit would cost more than the interface is worth. Here are good tips i found, of the switch-mode k+dcan usb cable user manual.
K DCAN CABLE PIN 7 8 HOW TO
How to use/switch/connect to K-Line or Dcan pin 7&8? I have one of those K+DCAN USB cables and I am confused about how to switch the modes of it.